 |
Back 4,729.75 KB
|
|
 |
Front 4,422.30 KB
|
|
 |
Left 5,357.62 KB
|
|
 |
Right 6,070.38 KB
|
|
 |
Running video cable under top gasket above doors 1,984.22 KB
|
|
 |
From inside the bed, yoiu can see the torx screw thatt needs to be removed to pull off the top trim piece, you can ALSO see the plastic retainer clip that has to be pressed back so you can pull the trim piece up. 3,916.28 KB
|
|
 |
Top trim piece removed entirely, also lets you see the support block for the rearward edge of the trim piece. (rubber thing with slot in the top of it.) This needed some lube to allow me to snap my trim piece back down properly. 2,425.57 KB
|
|
 |
After pulling Frunk liner out. Down at the bottom left, the piece of blue tape is holding the wires for the 48v Aux Power connection. 3,396.29 KB
|
|
 |
Positive and Negative 48v wires separated and insulation removed. 2,552.63 KB
|
|
 |
Shows the 48v-12v converter wired in, and the Wolfbox power plugged into it. 3,517.93 KB
|
|
 |
Ran the Wolfbox power line along the fender, into the door jam, then under 2,429.17 KB
|
|
 |
Power through the door jamb, then under the big gasket, then under the listtle square panel to get to the edige of the dash. Wire runs tucked under the lower dash edge. 2,998.21 KB
|
|
 |
How the camera looks 1,970.51 KB
|
|
 |
Back of Wolfbox from inside cabin. (awkward angle to take a photo!) 2,385.92 KB
|
|
 |
Kinda hard to see through the glass reflections... 2,831.12 KB
|
|
 |
How it looks from the drivers point of view. 3,406.35 KB
|
|