Finished and drilled couplers3464 viewsThis is the finished coupler assembly with all the screws that will be used to hold them together.Feb 13, 2009
|
|
Boring coupler shaft holes2252 viewsThis time we wanted to be SURE our boring bar wouldn't flex, so we built a much stronger one.
We also are using much better cutting tips.
Feb 13, 2009
|
|
Motor coupler work2312 viewsContinuing work on the couplerFeb 13, 2009
|
|
Finished Couplers and Flywheel mount2501 viewsThese are the finished couplers and the Flywheel mount.Feb 13, 2009
|
|
Starting the 2nd version of the Motor Coupler2497 viewsAfter our near-disaster with the 1st motor coupler, we decided to build the new one as a 2 piece unit. This will allow the motors to be separated if needed.Feb 13, 2009
|
|
Shortening the coupler2230 viewsWe did start with a piece of shaft that was too long, and decided it would be easier to cut off the excess with a saw, rather than cutting it all away with the lathe.Feb 13, 2009
|
|
Finishing the coupler2549 viewsHere we are putting the step in one end of the coupler so it can fit down into the end-bell of the motor.Feb 13, 2009
|
|
Starting the 1st version of the Motor Coupler4935 viewsHere we are starting work on the first version of the coupler to connect the 2 Impulse 9" motors.
This is going to be a single piece coupler that press-fits on both shafts.Feb 13, 2009
|
|
Boring the hole in the motor coupler2610 viewsHere we are boring the hole for the motor shaft. 1/2 the hole has to be a larger diameter since it's coupling a tail shaft to a main shaft.Feb 13, 2009
|
|
Finished Coupler3679 viewsThe finished coupler. (Well, I did have to have 2 keyways cut into it, and drill some holes for set screws after this.)Feb 13, 2009
|
|
Exhaust system4281 viewsExhaust system from the F250. 117 pounds, 14' long.Apr 16, 2008
|
|
Front Gas Tank3422 viewsApr 12, 2008
|
|
| 301 files on 26 page(s) |
 |
|
|
|
|
10 | |
|
|
|
|
