Motor-Motor mount test fit2576 viewsHow it fits on one of the motors.Feb 13, 2009
|
|
Motor-Motor mount welded2216 viewsHere is the mostly finished mount all welded together.Feb 13, 2009
|
|
Motor-Motor mount access holes2441 viewsIt was interesting putting the access holes in the mount.Feb 13, 2009
|
|
Motor-Motor mount rough2451 viewsHere is the mount after some work in the lathe on both the raw pieces.Feb 13, 2009
|
|
Motor-Motor mount body2324 viewsAnd a piece of old iron pipe from the same place.Feb 13, 2009
|
|
Motor-Motor mount ends3193 viewsWe started with some scrap plate steel from the local recycle place.Feb 13, 2009
|
|
Adapter Plate alignment finished2697 viewsThen we slid on the Motor adapter plate.
This allowed us to drill the holes to bolt the 2 plates together, and put in a couple of locating pins between them so they can be taken apart and re-assembled without shifting.Feb 13, 2009
|
|
Adapter Plate alignment, contd 22191 viewsThen we mounted the Bell Housing adapter plate.Feb 13, 2009
|
|
Adapter Plate alignment, contd2409 viewsHere the alignment tool has been pressed into the bell housing.
Feb 13, 2009
|
|
Adapter Plate alignment2316 viewsI had a big aluminum plate made into a bell-housing adapter plate, and another big aluminum plate for the Impulse 9 motor.
In order to get everything lined up with the transmission shaft properly, we built an alignment tool.
It fit snugly into the hole in the bell housing where the transmission mounts, and was the same diameter as the centering ring on the motor.Feb 13, 2009
|
|
Flywheel adapter - drilling holes2614 viewsDrilling and tapping the holes to bolt it to the flywheel.Feb 13, 2009
|
|
Flywheel adapter - finishing with the lathe2507 viewsFinished the lathe work, just needs drilling now.Feb 13, 2009
|
|
| 301 files on 26 page(s) |
 |
|
|
|
|
7 | |
|
|
|
|
